Whether it is a car, a large amusement facility or a small and medium-sized amusement facility, such as a bumper car, all need to be run in when they are put into use. What should be the running in period of the bumper car.

How about maintenance?

In the running in stage of the bumper car. The new friction contact surface has a certain roughness, and the contact area of the test machine is very small. Therefore, at the beginning of running in of the bumper car, the wear and tear are rapid, and with the running in, the rough surface is convex

The results show that the contact area increases gradually, the surface becomes smooth and smooth, and the wear rate decreases gradually. When it reaches a certain level, it tends to be stable, and this is the end of the running in stage. The amount of wear during this period is called the initial stage

Wear.

So, how to do the bumping and maintenance?

1、 Maintenance of bumper car

1. The inflation standard of the bumper car: between 1.8kg and 2kg (check once a day), and inflate it in time.

2. If there is any damage to the conductive wheel, replace it in time.

(check once a day)

3. Check whether the screws of the incoming power supply of the rectifier cabinet of the bumper car are loose (often check), and tighten them immediately if they are loose.

4. Add grease once a month to the small conductive wheel of bumper car. (the small conductive wheel must be removed)

5. The brake screw of the bumper car should not be too tight or too loose. The standard is that when the bumper car starts, it is the best to step on the accelerator for 2 to 3 seconds to start.

6. Check whether the mounting screw of the conductive wheel of the bumper car is loose, and the rubber on the screw of the conductive wheel shall not be cracked. If there is any crack, replace it in time (once a day).